THANKSGIVING CENTERPIECE
We have a lot to be thankful for in this great country we live in. Thanksgiving is a time to reflect on our bounty and blessings and to spend quality time with family and friends. It is just around the corner! Gather a few supplies and a package of Sticky Sticks to create this DIY turkey centerpiece to celebrate the Holiday!
Supplies:
Smoothfoam: one 3” cube, two 2-1/2” balls, one 6” wide x
1” thick disk
Sticky Sticks™: seven (6” jumbo craft sticks with self-adhesive
strip)
Cardstock: Autumn themed coordinating 12” cardstock, Kraft,
scraps of dark brown, orange, black (Close To My Heart, Huntington)
Burlap fabric
Jute twine
Cricut cuts: 1-3/4” scalloped medallions, 11 (cut from
Kraft cardstock), (CTMH Artiste Cricut Cartridge)
Dark Brown inkpad, wedge sponge or
dauber
Decoupage medium, brush, water bucket
Rubber stamps: 1” tall alphabet letters spelling “Thanks”;
2-1/2” square Fall themed
Serrated bladed knife or foam cutter
Scissors, paper cutter, pencil
Low melt glue gun and glue sticks
Toothpicks
1. Body:
Cut 1” up from one side of the disk.
This will be the bottom edge.
Trace around the disk onto cardstock for the front and the back. Cut 1”x 12” strips and adhere all pieces to
the disk (front, back and sides) using the decoupage medium. Repeat for the 3” cube, only leave one side
plain. Tail feathers: Cut ¾” x 12”
strips from the cardstock. Cut strip to
fit the front and back of one craft stick.
Adhere to the craft stick leaving the adhesive strip exposed. Repeat for each stick, rotating the
coordinating papers. Remove the adhesive
strip from one craft stick. Position and
adhere stick to the disk as shown.
Repeat for each stick. (*Do not
remove the release paper until positioning is exact. It is permanent.)
2. Head and wings:
Cut a 6” square of burlap. Wrap, smooth
and flatten burlap around one ball. Tie
jute twine around the burlap at the bottom of the ball; tightly knot and tie
the tails in a shoestring bow. Trim
excess for burlap and twine. For the wings: Cut the remaining 2” ball in two. Wrap each ball half in burlap and glue down
the edges to the flat side of each ball.
Trim excess fabric.
3. Assemble: Attach the head to the block body with a
toothpick. Adhere to secure. Repeat for the wings and to attach the body
to the disk as shown in the photo given. Attach the unfinished side of the
block to the disk.
4. Paper Embellishments: I used the Cricut machine to cut
out the paper medallions that spell “Thanks”.
A paper punch will give a similar effect. Stick-on alphabet letters might be an
alternative choice to the rubber stamps.
I used a rubber stamp with a Fall theme and cut around it to fit the front
of the body, slightly smaller than the block’s surface. The remaining paper medallions were glued to
the disk as shown.
5. To finish: Sponge the edges with
brown ink as desired. Loop and glue jute twine to the back of the tail
feathers. I used a round punch from matching
papers, sandwiched and glued the jute between each craft stick and the punched
circle of paper. Unravel the tails of
the 3-ply jute on each side of the turkey.
Come back and see us for lots more fun projects and ideas!
Happy Crafting!
Sticky Sticking across the Universe!
The Sticky Sticks Team
